Procedures

1020A20 CRANK CASE OIL SUMP - R + R CLEAN SEALS FOR SEALANT APPLICATION

Engines: 2.0 JTD 8V

Removing

- Position the vehicle on the lift. Op. 7055B54 UNDER-ENGINE GUARD - R R1. Undo the exhaust plug and collect the engine oil in a suitable container.

Engines: 2.0 JTD 8V

See in Op. 1084A161. Disconnect the electrical connection for the engine oil level sensor.

	Description	Connector
1	Engine oil level sensor	K032

2. Disconnect the sump oil return pipe.

Engines: 2.0 JTD 8V

1. Undo the perimeter retaining bolts securing the engine oil sump to the crankcase.2. Undo the bolts fixing the sump to the bellhousing.3. Using the tool, cut the sealant along the entire perimeter of the sump.

	Description	Code	Function
3	Blade	1.870.718.000	Engine oil sump removal

4. Remove the engine oil sump.

Engines: 2.0 JTD 8V

Refitting

Removing

- Clean the matching surfaces between the crankcase sump and the cylinder block/crankcase.- Apply sealant to the oil sump fitting surface.

	Description	Qty.	Component	Type	Classification
.	Dow Corning 7091	-	OIL SUMP	Silicone sealant	-

- Position the crankcase sump in its housing with no axial deviation- Fit the crankcase sump.- Tighten the bolts fixing the crankcase sump to the recommended torque.

	Value - daNm	Fastening	Component	Ø
.	1,6	Bolt	OIL SUMP	-

- Connect the electrical connection for the engine oil level sensor.

	Description	Connector
.	Engine oil level sensor	K032

- Connect the sump oil return pipe.- Tighten the engine oil sump plug and replace the gasket.- Fill the vehicle with suitable engine oil. Op. 0010T11 ENGINE OIL CHECK LEVEL AND TOP UP Op. 7055B54 UNDER-ENGINE GUARD - R R- Remove the vehicle from the lift.