FIAT / DUCATO 244eLearn workshop manual · English · Offline edition
Procedures

1042A34 CNG CYLINDER RECHARGE VALVE - R R

Engines: 2.0 16V
Engines: 2.0 16V

RemovingManual illustration 20

RefittingManual illustration 21
Position the vehicle on the lift.Proceed with draining the high pressure circuit following the instructions described in the procedure below:Op. 1042A02 C.N.G. - FUEL SYSTEM SAFETY CHECKOp. 1042A30 CNG CYLINDER RECHARGE VALVE COCK - R R1. Undo the retaining bolts.2. Remove the load carrying compartment side trim cover.
Manual illustration 244006723
Engines: 2.0 16V
1. Remove the retaining buttons (1b) using the tool (1a).
[symbol: attrezzi.tif]DescriptionCodeFunction
1aKnife1.878.077.000Remove fastening studs
2. Remove the side load carrying compartment trim.
Manual illustration 244006724
Engines: 2.0 16V
1. Undo the bands (1a) and release the safety pipe (1b).2. Undo the connector and disconnect the canister repressurizing pipe.3. Undo the ring nut (3a) and remove the plastic protective cover (3b).
Manual illustration 244006725
Engines: 2.0 16V
1. Remove the seal.
Manual illustration 244006726
Engines: 2.0 16V
1. Remove the canister repressurizing valve.
Manual illustration 244006727
Engines: 2.0 16V

RefittingManual illustration 21

RemovingManual illustration 20
Place the canister repressurizing valve in position.Fit the seal in the housing.Fit the protective plastic cover and tighten the ring nut.Connect the canister repressurizing pipe and tighten the connector to the recommended torque.
[symbol: coppie.tif]Value daNmFasteningComponentØ  
-2.8Connector--
Restore the position of the safety pipe and secure it using the special bands.Place the load carrying compartment side trim in position and secure it using the special fixing buttons.Place the load carrying compartment side trim cover in position and tighten the fixing bolts.Op. 1042A30 CNG CYLINDER RECHARGE VALVE COCK - R RRemove the vehicle from the lift.