1. Remove the air delivery sleeve to the air-air heat exchanger (intercooler).
Engines: 2.3 JTD 16V
1. Undo the bolts securing the power steering fluid reservoir bracket.2. Disconnect the oil pipes from the reservoir.3. Remove the power steering fluid reservoir complete with bracket.- Seal both pipes with plugs.
Engines: 2.3 JTD 16V
1. Remove the second section of the air delivery sleeve to the air-air heat exchanger (intercooler).
Engines: 2.3 JTD 16V
1. Disconnect the electrical connection of the right front light cluster.
Description
Connector
1
Right headlamp
F011
2. Disconnect the collars at both ends and remove the air pipe from intercooler to intake manifold.
Engines: 2.3 JTD 16V
1. Undo retaining bolt (1a) and remove the engine oil dipstick (1b).
- Fit the engine oil dipstick pipe and tightenn the retaining bolt.- Fit the air pipe from intercooler to intake manifold and connect the collars to both ends.- Connect the electrical connection of the right front light cluster.
Description
Connector
.
Right headlamp
F011
- Fit the second section of the air delivery sleeve to the air-air heat exchanger (intercooler).- Fit the power steering fluid reservoir complete with bracket.- Connect the fluid pipes to the reservoir and tighten the power steering system fluid reservoir bracket bolts.- Fit the air delivery sleeve to the air-air heat exchanger (intercooler).- Fill the power steering system with appropriate fluid.
- Position the engine oil dipstick pipe in its housing.- Position the brackets on the fastenings.- Tighten the fixing bolts. See in Op. 1048B22 See in Op. 1048B14
See in Op. 1060F50 Op. 7055B54 UNDER-ENGINE GUARD - R R- Position a container underneath the engine to collect the engine oil.1. Undo the drain plug in the crankcase sump and leave the oil to drain into the container.
Engines: 2.0 JTD 8V
1. Undo the engine oil dipstick pipe upper fixing bolts.- Raise the lift.2. Undo the lower bolt (2a) and remove the engine oil dipstick pipe (2b).
- Fit the engine oil dipstick pipe.- Tighten the engine oil dipstick pipe lower fixing bolt to torque.- Lower the lift.- Tighten the engine oil dipstick pipe upper fixing bolts to torque.- Clean the drain plug and tighten it to the recommended torque.- Lubricate the new oil filter seal with engine oil and tighten it fully.- Refill the lubrication circuit with the recommended oil.
