FIAT / DUCATO 244eLearn workshop manual · English · Offline edition
Procedures

2710A20 WHEEL END CONSTANT VELOCITY JOINT (ONE), L/H OR R/H - R + R WITH DRIVE SHAFT REMOVED - INCLUDES BOOT REPLACEMENT

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V
Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

RemovingManual illustration 20

RefittingManual illustration 21
- Position the driveshaft in a vice.1. Remove the retaining band and move the protective boot back.2. Remove the constant velocity joint from the driveshaft.3. Clean the grease from the inner area housing the bearing then, using tools (3a) and (3b) and pliers on the circlip inside the joint simultaneously, remove the constant velocity joint bearing retaining ring (3c).4. Then remove the protective boot (4a) removing the retaining band (4b).
Manual illustration 244000499DescriptionCodeFunction
3aAdapator1.846.061.000Front differential bearing removal
Manual illustration 244000499DescriptionCodeFunction
3bMallet1.847.017.001Front differential bearing removal
Manual illustration 244003755
Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

RefittingManual illustration 21

RemovingManual illustration 20
- Check that the driveshaft is not distorted or off centre in the area where the joint is fitted and that the area in contact with the seal is not worn.- Position the new protective boot on the driveshaft.- Fit the bearing on the driveshaft.- Fill the protective boot and the bearing with suitable grease.
Manual illustration 244000495DescriptionQty.ComponentTypeClassification
.TUTELA MRM 2-DRIVESHAFT CONSTANT VELOCITY JOINTSGrease-
- Position the constant velocity joint and fit it on the bearing by applying gentle pressure.- Secure the protective boot to the joint using two new bands.