FIAT / DUCATO 244eLearn workshop manual · English · Offline edition
Procedures

2710A24 DIFFERENTIAL END CONSTANT VELOCITY JOINT (ONE) L/H OR R/H - R + R WITH DRIVE SHAFT REMOVED - INCLUDES BOOT REPLACEMENT

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V
Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

RemovingManual illustration 20

RefittingManual illustration 21
- Position the driveshaft in a vice.1. Remove the circlip (1a) and release the three-lobe joint (1b) from the driveshaft.2. Remove the retaining band (2a) and move the protective boot (2b) back.
Manual illustration 244003756
Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

RefittingManual illustration 21

RemovingManual illustration 20
- Check that the driveshaft is not distorted or offset in the area where the joint is fitted and that the area in contact with the seal is not worn.- Fit the three-lobe joint on the driveshaft in the special housing securing it using the special flexible clip.- Fill the protective boot and the bearing with suitable grease.