Procedures

3340B70 RIGID PIPE ONE LEFT OR RIGHT FROM CONNECTOR TO INTERMEDIATE HOSE R R

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

Removing

- Position the vehicle on the lift.- Remove the protective cap from the bleed valve on the rear brake caliper.- Connect the recovery device (pipe and reservoir) to the rear brake caliper bleed valve.- Operate the brake pedal until the brake/clutch reservoir is drained.1. Undo the connector for the rigid pipe from the connector to the intermediate flexible pipe.

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

- Release the rigid pipe retaining spring from the connector at the intermediate flexible pipe.1. Undo the rigid pipe from the connector at the intermediate flexible pipe from the intermediate flexible pipe to the rear brakes.

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

1. Remove the rigid pipe releasing it from the springs.

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

Refitting

Removing

- Check that the rigid pipe from the connector to the intermediate flexible pipe is not damaged.- Fit the rigid pipe from the connector to the intermediate flexible pipe and attach it to the springs.- Tighten the connector for the rigid pipe from the connector to the intermediate flexible pipe.

	Value - daNm	Fastening	Component	Ø
.	(Rigid pipe side) 1.2 - 2.2	Connector	RIGID PIPE FROM CONNECTOR TO REAR BRAKES	M10

- Tighten the connector for the rigid pipe from the connector to the support with the intermediate flexible pipe to the rear brakes.

	Value - daNm	Fastening	Component	Ø
.	(Support side with intermediate flexible pipe to rear brakes) 1.2 - 2.2	Connector	RIGID PIPE FROM CONNECTOR TO REAR BRAKES	M10

Op. 0010T65 HYDRAULIC BRAKE SYSTEM BLEED AIR- Remove the vehicle from the lift.- Test the operation of the braking system.