Procedures

4410D13 FRONT SUSPENSION BEAM - R R

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

Removing

- Position the vehicle on the lift.- Remove the front wheels. Op. 7055B54 UNDER-ENGINE GUARD - R R1. Slightly loosen the upper nut fixing the anti-roll bar connecting rod.2. Undo the lower nut fixing the anti-roll bar connecting rod.3. Keep the washer (3a) and the bush (3b).

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

- Continue working on both sides of the vehicle.1. Undo the front bolt for the track control arm.2. Undo the bolts fixing the rear pin.3. Gently lower the track control arm.4. Keep the washer (4a) and the bush (4b).

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

Op. 4410D14 FRONT SUSPENSION CROSSBEAM - R+R WITH WISHBONES REMOVED

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

Refitting

Removing

Op. 4410D14 FRONT SUSPENSION CROSSBEAM - R+R WITH WISHBONES REMOVED- Place the bushes and the washers in position, then raise the track control arms until they are in the correct position.1. Tighten the inner bolt fixing the rear pin.

	Value - daNm	Fastening	Component	Ø
1	17.3 - 25.5	Inner bolt	FRONT TRACK CONTROL ARM	M16x1.5

2. Tighten the outer bolt fixing the rear pin.

	Value - daNm	Fastening	Component	Ø
1	15.6 - 22.5	Outer bolt	FRONT TRACK CONTROL ARM	M16x1.5

3. Tighten the front bolt.

	Value - daNm	Fastening	Component	Ø
3	22.9 - 33.2	Front bolt	FRONT TRACK CONTROL ARM	M18x1.5

4. Position the bush and the washer and tighten the lower connecting rod fixing nut.

	Value - daNm	Fastening	Component	Ø
4	5.1 - 7.4	Lower nut	ANTI-ROLL BAR CONNECTING ROD	M12x1.25

5. Tighten the upper connecting rod fixing nut.

	Value - daNm	Fastening	Component	Ø
5	8.2- 11.9	Upper nut	ANTI-ROLL BAR CONNECTING ROD	M12x1.25

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

Op. 7055B54 UNDER-ENGINE GUARD - R R- Refit the front wheels.- Remove the vehicle from the lift.