4450A10 FRONT WHEEL GEOMETRY - CHECK USING OPTICAL EQUIPMENT - INCLUDES FRONT WHEEL TOW-IN ADJUSTMENT IF NECESSARY

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

- Before checking the wheel geometry, the following checks must be carried out.- Tyre inflation pressure.- Eccentricity and orthogonality of the wheel rims which should not be more than 3 mm.- Wheel bearing endfloat.- Clearance between the steering knuckle and track control arm joint pin.- Steering track rod end.- Let the suspension bed in driving the vehicle over an uneve section of road.- Have the vehicle ready unladen, complete with spare wheel, tools, accessories and a full fuel tank.1. Check the wheel camber angle "%agr".

	Subject	Value
1	Front wheel camber	-
-	Camber angle "%agr"	0° ± 30'

- The camber angle cannot be adjusted.

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

1. Measure the distances "a" and "b" between the outer points of the wheel rim on the front axle and measure the front wheel toe in.

	Subject	Value
1	Front wheel toe in	mm
-	Distance a - b	0 ± 1

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

1. If the toe in figure measured is different from the recommended value, work symmetrically on the steering rods, after having loosened the fixing nuts and observing the following warnings.