1. Use the tool described below to extract the oil seal.2. Position the tool extraction jaws in the oil seal splining.3. Secure the extraction pincers in position using retaining bolts.4. Tighten the tool pin (4a) to remove the oil seal (4b) from its seat.
Description
Code
Function
1
Extractor
99340057
Extracting timig side crankshaft element
Engines: 2.3 JTD 16V
1. Undo the bolts (1a) and remove the crankshaft front cover (1b) with vacuum unit and oil pump incorporated plus the gasket (1c).
- Fit a new front crankshaft front cover gasket.- Position the crankshaft front cover with vacuum unit and oil pump incorporated and screw in the fixing bolts without tightening them.1. Centre the crankshaft front cover with the vacuum unit and oil pump (1a) incorporated using the tool (1b).
Description
Code
Function
1b
Locator
99396037
Tool for locating front crankshaft cover
Engines: 2.3 JTD 16V
1. Tighten the crankshaft front cover fixing bolts in the recommended order.
Value - daNm
Fastening
Component
Ø
.
1.0
Bolt
ENGINE OIL PUMP
M6 X 1
Engines: 2.3 JTD 16V
1. Use the tool described below to fit the timing side oil seal.
Description
Code
Function
1
Fitting tool
99346254
Front cover gasket fitting
2. Tighten the threaded tool pin until it comes into contact with the crankshaft drive gear seat.3. Position a new oil seal in its seat.4. Position introduction tool (4a) in contact with the oil seal and tighten the nut (4b) to fully fit the oil seal into its seat on the front cover.
