FIAT / DUCATO 244eLearn workshop manual · English · Offline edition
Procedures

3380A40 LINKAGE SUPPORTS AND IDLERS - R+R

Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V
Engines: 2.0 16V

RemovingManual illustration 20

RefittingManual illustration 21
- Position the vehicle on the lift. Op. 1042E60 CNG CYLINDER UNIT PROTECTION SEAL - R R1. Loosen the handbrake cable (1a) and remove the split pin (1b), then release the handbrake cable (1c).2. Undo the retaining bolts (2a) and remove mounting (2b).
Manual illustration 244003969
Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V

RefittingManual illustration 21

RemovingManual illustration 20
- Fit the handbrake linkage rear idler and, using a new riveter and new rivets, fasten it to the bodyshell.- Connect the handbrake cable to the idler.- Connect the section of the handbrake cable with the rear brakes to the idler.- Fit the handbrake linkage front idler and, using a new riveter and new rivets, fasten it to the bodyshell.- Connect the handbrake cable to the idler.- Connect the section of the handbrake cable with the rear brakes to the idler.- Fit the heat shield and fasten it to the bodyshell using the fixing bolts. Op. 1076B20 REAR EXHAUST SILENCER - R + R- Fit the handbrake cable mouting and tighten the fixing bolts.- Position the handbrake cable and connect the two sections positioning the split pin. Op. 1042E60 CNG CYLINDER UNIT PROTECTION SEAL - R R- Proceed with the adjustment of the handbrake cable. Op. 3380A04 HANDBRAKE - CHECK TRAVEL- Remove the vehicle from the lift.
Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V
Op. 1076B20 REAR EXHAUST SILENCER - R + R-1. Undo the fastening bolts (1a) and remove the heat shield (1b) for the exhaust pipe.
Manual illustration 244003970
Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V
1. Disconnect the handbrake cable from the rear brakes.2. Disconnect the handbrake cable from the idler.3. Using a drill with a suitable helical point, remove the fixing rivets.4. Remove the linkage rear idler.
Manual illustration 244003971
Engines: 2.0 16V, 2.0 JTD 8V, 2.3 JTD 16V, 2.8 JTD 8V
1. Disconnect the handbrake cable from the rear brakes.2. Disconnect the handbrake cable from the idler.3. Using a drill with a suitable helical point, remove the fixing rivets.4. Remove the linkage rear idler.
Manual illustration 244003972